Siemens SENTRON PAC2200CLP, Руководство по эксплуатации продукта, Страница: 65 / 130

Commissioning
6.3 Parameterizing the device
PAC2200CLP
Equipment Manual, 06/2021, L1V30820585B-02
63
Every repeated incorrect password entry results in an extension of the delay period between
entry possibilities.
Note
If you have forgotten the password, please contact Technical Support. You will receive a new
password from them.
"Hardware write-protection" parameter
No write access is possible, even if password information is used. In order to gain write
access, the hardware write protection must be deactivated.
ON: Hardware write protection is activated.
OFF: Hardware write protection is deactivated
Activation or deactivation of the password protection must be confirmed on the device.
Request message "PRESS SW" appears on the display for 15 minutes. By pressing the SW
button on the device during this phase, the protection function is activated or deactivated.
If the button has not been pressed once 15 minutes have expired, the changes are not
applied and the request message on the device disappears.
"Access protection IP filter" parameter
The IP filter is a configurable access protection. If activated, Modbus TCP write commands are
only accepted if the remote station is located in the same subnet.
Note
It is recommended to activate the hardware write protection on the device.
If you want to use the device for billing purposes, please refer to the notes at the end of the
chapter Parameterizing via the device menu (Page 63).
6.3.2 Parameterization via the device menu
The PAC2200CLP device can be parameterized via the "Settings" menu option. See chapter
Menu-based navigation (Page 51).
"Language" parameter
The language of menu-based navigation and of the measured value displays can be set in the
"Language" menu item.
Selection Range Factory setting
Language English, German English
Phase designation
• L1, L2, L3
• a, b, c
L1, L2, L3