Siemens SE25E259EU/39, Руководство по эксплуатации

Страница: 7 / 28

en
7
To ensure good washing results, the
dishwasher requires soft water, i.e.
containing low amounts of lime, otherwise
white limescale will be deposited on the
utensils and inner container.
Tap water above 9° Clarke (from set value
•
:
‹‚
) must be softened. The water is
softened with salt (regeneration salt) in the
water softening system of the dishwasher.
The setting and therefore the required
amount of salt depends on the degree of
hardness of your tap water (see table).
Setting
The amount of salt dispensed can be
set in 4 stages
depending on the hardness of your water.
Accordingly 0, 1, 2 or 3 displays are lit
(see table).
–
Find out about the hardness
value of your tap water. Your water
utility company will help you with this.
– Setting can be found in the water
hardness table.
– Close the door.
– Rotate the programme selector
8
from the 12 o’clock position anti-
clockwise by one notch.
– Switch on main switch
(
and hold
down for at least 3 sec.
The salt refill indicator
h
flashes
and the lamps above the symbols
6
and
,
light up. (Hardness value has
been set to 2 at the factory.)
To change the setting:
– Rotate programme selector
8
.
You can select a set value between 0
and 3 according
to the hardness of your water.
If the lamps
6
,
,
and “End” light up,
the maximum set hardness value has
been reached. If the programme
selector is turned further, the lights go
out and the set hardness value is set to
level 0.
– Switch off the main switch
(
.
The chosen setting has now been
stored.
Water hardness table
Water softening system
(QG
:DWHU
KDUGQHVV
YDOXHƒG+
VRIW
PHGLXP
KDUG
KDUG
PPROO +DUGQHVV
UDQJH
6HWWLQJ