Configuration Using Web Based Management and the Command Line Interface
1. Connect the access point with the
HiPath Wireless Controller
and with the
configuration computer over the Ethernet interface.
2. If the access point is brand new, assign an IP address.
If a DHCP server is visible, the access point is assigned an IP address
automatically. Otherwise, assign the access point an IP address using the
Primary Setup Tool
(PST) (see Section 4, Configuring the IP Address with the
Primary Setup Tool).
3. Connect your configuration computer with the access point in the Web browser
and open Web Based Management (WBM) to the
System Information
page
with
W788-2RR > System
(see Sections 5.1 and
Fehler! Verweisquelle
konnte nicht gefunden werden.
).
4. In
the
Device Mode
list, select
HiPath Access Point
and confirm this with
Set
Values
. During configuration make sure that the SCALANCE W78x is assigned
an IP address suitable for the HiPath Wireless Controller.
5. A blue message "Restart to apply changes" appears above the
System
Information
WBM page.
Click on the blue message. The
Restart
window opens.
Confirm the restart by clicking on the
Restart
button.
The access point runs a restart.
Operating Instructions SCALANCE W78x
107
C79000-G8976-C184-07
