The parameter has the following meaning:
Parameters
Description
Range of values / note
vlan-id
Number of the addressed VLAN
1 ... 4094
Result
The Agent VLAN ID has been changed.
Further notes
You reset the
dot1q-vlan
setting with the
base bridge-mode
command.
7.2.3
Commands in the interface configuration mode
This section describes commands that you can call up in the interface configuration mode.
Depending on the Interface selected, various command sets are available.
In the Global configuration mode, enter the
interface
command to change to this mode.
Commands relating to other topics that can be called in the interface configuration mode can
be found in the relevant sections.
● If you exit the Interface configuration mode with the
exit
command, you return to the Global
configuration mode.
● If you exit the Interface configuration mode with the
end
command, you return to the
Privileged EXEC mode.
7.2.3.1
switchport acceptable-frame-type
Description
With this command, you configure which types of frames the interface accepts.
Requirement
You are in the Interface Configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
Syntax
Call up the command with the following parameters:
switchport acceptable-frame-type{all|tagged}
Network structures
7.2 VLAN
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
290
Configuration Manual, 09/2017, C79000-G8976-C324-08