Siemens S35i, Руководство по обслуживанию

Страница: 23 / 31

V1.0
20
STEP 1:
Check that the Lower Housing Assembly, Control Board Assembly and Upper Housing
Assembly are in good order. Check if the Buzzer sealing was installed on the Control Board.
N e w U p p e r a n d L o w e r C a s i n g m u s t b e u s e d . A l l
c o n t a c t p i n s m u s t n o t b e d i r t y , d a m a g e d o r b e n t !
I f a n y p a r t i s n o t O . K p l e a s e r e p l a c e i t w i t h a n e w
p a r t .
PHOTO 2.16 ASSEMBLE S35i – STEP 1 PHOTO 2.17 ASSEMBLE S35i – STEP 2
STEP 2:
Clear the dust on the display screen of the Display module and the Upper Housing by an air gun.
Place the Control Board Assembly in the Upper Housing as illustrated in PHOTO 2.17.
Check and ensure the display is free from dust.
STEP 3:
Close the device by putting on the Lower casing section as illustrated in PHOTO 2.18. Hold the
phone and use both hands to close the casing starting from the catches at the top part near the
antenna, watch out for leaving any finger marking on the display screen.