Siemens RUGGEDCOM WIN7014, Руководство по установке

Страница: 17 / 48

RUGGEDCOM WIN7014
Installation Guide
Chapter 2
Installing the Base Station
Unpacking the Base Station 9
1. Review the relevant certification information for any regulatory requirements. For more information, refer to
Section 5.1, “Approvals” .
2. Select an appropriate site and perform a site survey. For more information, refer to Section 2.3, “Site
Preparation and Precautions” .
3. Unpack and inspect the base station components. For more information, refer to Section 2.2, “Unpacking the
Base Station” .
4. Mount the base station to a pole, wall or tower. For more information, refer to Section 2.5, “Mounting the
Base Station” .
5. Install and connect the antenna(s). For more information, refer to Section 2.6, “Installing Antennas” .
6. For Class I, Division 2 hazardous locations only, connect a RUGGEDCOM WIN1212. For more information,
refer to Section 2.8.4, “Installing the Hazardous Location Kit” .
7. Make sure the base station is grounded. For more information, refer to Section 2.7, “Grounding the Base
Station” .
8. Connect the base station to a power source and the network. For more information, refer to Section 2.8,
“Connecting Power and Data” .
9. Seal all cable connections. For more information, refer to Section 2.9, “Weatherproofing the Base Station” .
10. Configure the base station. For more information, refer to Section 3.2, “Configuring the Base Station” .
Section 2.2
Unpacking the Base Station
The following items are included in the RUGGEDCOM WIN7014 package:
Item Quantity
RUGGEDCOM WIN7014 Base Station 1
Pole/wall/tower mounting kit 1
DB9 Female to 3-Pin Male RS232 Cable, 2 m (6.6 ft) 1
GPS antenna 1
Power supply for PEC (copper) and SFA (optical) configurations 1
coaxial cable, 900 mm (35.4 in) long 1
Radio Frequency (RF) antenna cables, CAT-5, 1.5 m (4.9 ft) long 2
When unpacking the base station, do the following:
1. Inspect the package for damage before opening it.
2. Visually inspect each item in the package for any physical damage.
3. Verify all items are included.
IMPORTANT!
If any item is missing or damaged, contact Siemens for assistance.