Installing the Device
2.5.4 Connecting a GPS Antenna
NOTICE
A site survey is recommended prior to any installation to help determine the best lo-
cation for the GPS antenna. For assistance, contact a Siemens Sales representative.
NOTICE
Although it is impossible to protect the antenna from a direct lightning strike, the
antenna and connected components can be protected from secondary effects
through site selection and by installing protection devices.
Install the antenna at least 15 m (49 ft) away from and lower than any structures
that attract lightning. GPS antenna damage is usually not the result of a direct light-
ning strike, but due to high currents induced by the effects of a lightning strike on
a nearby structure. Lightning arrestors should also be installed in the antenna line
to protect the receiver and connected devices. If a lightning arrestor is installed, it is
important to make sure it has a low impedance path to ground.
To promote signal reception and avoid signal saturation at the receiver input, the
overall GPS system requires a relative gain between 5 and 18 dBi.
Use only low loss, 50 Ω coaxial cabling when connecting the GPS and any other op-
tional components to the RUGGEDCOM RX1400.
Note
Using any length of coaxial cable will add some time delay to the GPS signal, which
degrades the accuracy of the calculated time and position. The time delay is depen-
dent on the type of dielectric material in the cable and ranges from 1 to 2 ns/ft. The
table below gives some examples of the delay that can be expected based on the di-
electric type.
Dielectric Type
Time Delay (ns/ft)
Propagation Velocity (% of c)
Solid Polyethylene (PE)
1.54
65.9
Foam Polyethylene (FE)
1.27
80.0
Foam Polystyrene (FS)
1.12
91.0
Air Space Polyethylene (ASP)
1.15 to 1.21
84 to 88
Solid Teflon (ST)
1.46
69.4
Air Space Teflon (AST)
1.13 to 1.20
85 to 90
To connect a GPS antenna, do the following:
1. Mount the antenna to a pole or wall in an area that provides good signal cover-
age and is away from any signal noise emanating from other communications
equipment. Make sure 90° of the sky is visible to the antenna.
RUGGEDCOM RX1400
Installation Manual, 09/2019, C79000-G8976-1103-13
19
