Siemens RUGGEDCOM ROX II, Руководство пользователя

Страница: 619 / 798

RUGGEDCOM ROX II
CLI User Guide
Chapter 13
Unicast and Multicast Routing
Viewing a List of Neighbors 573
• Section 13.11.12.2, “Adding a Neighbor”
• Section 13.11.12.3, “Configuring the Distribution of Prefix Lists”
• Section 13.11.12.4, “Tracking Commands”
• Section 13.11.12.5, “Deleting a Neighbor”
Section 13.11.12.1
Viewing a List of Neighbors
To view a list of neighbors configured for an IPv4 address family, type:
show
running-config routing bgp address-family ipv4 vrf vrf neighbor
Where:
•
vrf
is the chosen VRF instance
If neighbors have been configured, a table or list similar to the following example appears:
show running-config routing bgp address-family ipv4 vrf VRF1 neighbor
routing bgp
address-family ipv4
vrf VRF1
neighbor 192.168.12.30
remote-as 1
no ebgp-multihop
no maximum-prefix
no next-hop-self
no password
no disable-connected-check
no soft-reconfiguration
no weight
no route-map in
no route-map out
!
!
!
!
If no neighbors have been configured, add neighbors as needed. For more information, refer to
Section 13.11.12.2, “Adding a Neighbor” .
Section 13.11.12.2
Adding a Neighbor
To add a new neighbor to an IPv4 address family, do the following:
1. Make sure the CLI is in Configuration mode.
2. Add the neighbor by typing:
routing
bgp address-family ipv4 vrf vrf neighbor address
Where:
•
vrf is the chosen VRF instance
•
address
is the IP address of the neighbor
3. Configure the neighbor settings by configuring the following parameter(s):