Siemens RUGGEDCOM ROX II, Руководство пользователя, Страница: 588 / 798

Chapter 13
Unicast and Multicast Routing
RUGGEDCOM ROX II
CLI User Guide
542 Managing MPLS
1. Make sure the CLI is in Configuration mode.
2. Delete the key by typing:
• For Standard OSPF Routes
no routing ospf interface name message-digest-key id
• For VRF Routes via OSPF
no
routing ospf vrf vrf interface name message-digest-key id
Where:
•
vrf
is the name of the chosen VRF
•
name
is the name of the routing interface
•
id
is the ID for the message digest key
3. Type commit and press Enter to save the changes, or type revert and press Enter to abort.
Section 13.10
Managing MPLS
MPLS (Multi-Protocol Label Switching) operates between Layer 2 and Layer 3 of the OSI (Open Systems
Interconnection) model and provides a mechanism to carry traffic for any network layer protocol. MPLS makes
forwarding decisions based on labels where the labels are mapped to destination IP networks. MPLS traffic flows
are connection-oriented, as they operate on pre-configured LSPs (Label Switch Paths) built based on the dynamic
Label Distribution Protocol (LDP), or through static label bindings.
CONTENTS
• Section 13.10.1, “Viewing the Status of IP Binding”
• Section 13.10.2, “Viewing the Status of the Forwarding Table”
• Section 13.10.3, “Enabling/Disabling MPLS”
• Section 13.10.4, “Managing the MPLS Interfaces”
• Section 13.10.5, “Managing Static Label Binding”
• Section 13.10.6, “Managing Static Cross-Connects”
• Section 13.10.7, “Managing LDP”
Section 13.10.1
Viewing the Status of IP Binding
To view the status of the IP binding on the device, type:
show mpls status ip-binding
If IP binding has been configured, a table similar to the following example appears:
ruggedcom# show mpls status ip-binding
LOCAL REMOTE
PREFIX LABEL NEXT HOP LABEL
----------------------------------------------------
1.1.1.1/32 17 192.168.10.1 imp-null