Siemens RUGGEDCOM ROX II, Руководство пользователя, Страница: 456 / 798

Chapter 12
Tunneling and VPNs
RUGGEDCOM ROX II
CLI User Guide
410 Viewing a List of Pre-Shared Keys
• Section 12.8.5.3, “Deleting a Pre-Shared Key”
Section 12.8.5.1
Viewing a List of Pre-Shared Keys
To view a list of pre-shared keys, type:
show running-config tunnel ipsec preshared-key
If pre-shared keys have been configured, a table or list similar to the following example appears:
ruggedcom# show running-config tunnel ipsec preshared-key
tunnel
ipsec
preshared-key 192.168.12.1 192.168.12.2
key $4$9YslfOBfkyYV8c1tqN4IDw==
!
!
!
If no pre-shared keys have been configured, add pre-shared keys as needed. For more information, refer to
Section 12.8.5.2, “Adding a Pre-Shared Key” .
Section 12.8.5.2
Adding a Pre-Shared Key
To add a pre-shared key, do the following:
1. Make sure the CLI is in Configuration mode.
2. Add the pre-shared key by typing:
tunnel ipsec preshared-key [ remote-address | local-address ] key key
Where:
•
remote-address is the remote IP address
•
local-address
is the local IP address
• key is the is the content of the pre-shared key
3. Configure the following parameter(s) as required:
Parameter Description
key { key } Synopsis: A string 1 to 8192 characters long
The pre-shared key.
This parameter is mandatory.
4. Type commit and press Enter to save the changes, or type revert and press Enter to abort.
Section 12.8.5.3
Deleting a Pre-Shared Key
To delete a pre-shared key, do the following: