Siemens RUGGEDCOM ROX II, Руководство пользователя

Страница: 413 / 798

RUGGEDCOM ROX II
CLI User Guide
Chapter 12
Tunneling and VPNs
Managing In/Out Interfaces 367
1. Make sure the CLI is in Configuration mode.
2. Delete the filter by typing:
no security virtualswitch-filter virtualswitch name rule rule
Where:
•
name
is the name of the virtual switch filter
• rule is the name of the rule
3. Type commit and press Enter to save the changes, or type revert and press Enter to abort.
Section 12.1.7
Managing In/Out Interfaces
In/out interfaces for virtual switch filters represent the interface being monitored by the filter ( in interface) and the
destination interface ( out interface) for network traffic that meets the filter's criteria.
CONTENTS
• Section 12.1.7.1, “Viewing a List of In/Out Interfaces”
• Section 12.1.7.2, “Adding an In/Out Interface”
• Section 12.1.7.3, “Deleting an In/Out Interface”
Section 12.1.7.1
Viewing a List of In/Out Interfaces
To view a list of in/out interfaces that can be used by a virtual switch filter, type:
show
running-config security virtualswitch-filter virtualswitch name rule rule [ in-interface | out-
interface ]
Where:
•
name
is the name of the virtual switch filter
•
rule
is the name of the rule
If in/out interfaces have been configured, a table or list similar to the following example appears:
ruggedcom# show running-config security virtualswitch-filter virtualswitch vs1 rule in-interface | tab
NAME NAME
--------------------
ipv6
switch.0010
iso
switch.0010
goose
switch.0010
!
!
!
If no in/out interfaces have been configured, add interfaces as needed. For more information, refer to
Section 12.1.7.2, “Adding an In/Out Interface” .