Chapter 12
Tunneling and VPNs
RUGGEDCOM ROX II
CLI User Guide
366
Adding a Rule to a Virtual Switch Filter
Parameter
Description
dstmac { dstmac }
Synopsis:
A string 17 characters long
The required destination MAC address for incoming frames.
proto { proto }
Synopsis:
{ iso, arp, ipv4, ipv6 } or a string
The pre-defined protocol or hex-string (i.e. 0x88A2) used to create the frames.
This parameter is mandatory.
5. Type
commit
and press
Enter
to save the changes, or type
revert
and press
Enter
to abort.
6. Add the rule to a virtual switch filter. For more information, refer to
Section 12.1.6.4, “Adding a Rule to a
.
Section 12.1.6.4
Adding a Rule to a Virtual Switch Filter
To add a rule to a virtual switch filter, do the following:
1. Make sure the CLI is in Configuration mode.
2. Add the rule by typing:
security
virtualswitch-filter virtualswitch
name
rule
rule
Where:
•
name
is the name of the virtual switch filter
•
rule
is the name of the rule
3. Configure the in/out interfaces for the rule. For more information, refer to
Section 12.1.7.2, “Adding an In/Out
.
4. Type
commit
and press
Enter
to save the changes, or type
revert
and press
Enter
to abort.
Section 12.1.6.5
Deleting a Rule
To delete a rule used to filter virtual switch traffic, do the following:
1. Make sure the CLI is in Configuration mode.
2. Delete the rule by typing:
no
security virtualswitch-filter rules
rule
Where:
•
rule
is the name of the rule
3. Type
commit
and press
Enter
to save the changes, or type
revert
and press
Enter
to abort.
Section 12.1.6.6
Deleting a Rule from a Virtual Switch Filter
To delete a rule from a virtual switch filter, do the following:
Содержание RUGGEDCOM ROX II
