RUGGEDCOM ROS
User Guide
Chapter 5
Setup and Configuration
Adding an SNMP User
199
Figure 128: SNMP Users Table
If users have not been configured, add users as needed. For more information, refer to
.
Section 5.6.1.2
Adding an SNMP User
Multiple users (up to a maximum of 32) can be configured for the local SNMPv3 engine, as well as SNMPv1 and
SNMPv2c communities.
NOTE
When employing the SNMPv1 or SNMPv2c security level, the
User Name
parameter maps the
community name with the security group and access level.
To add a new SNMP user, do the following:
1. Navigate to
Administration
»
Configure SNMP
»
Configure SNMP Users
. The
SNMP Users
table appears.
1
Figure 129: SNMP Users Table
1.
InsertRecord
2. Click
InsertRecord
. The
SNMP Users
form appears.
