8/50
2015-02-27
CE1G2208xx
Note 2: If the radio clock is not active or not present, the time change always takes place at 02:00 on the Sunday before the set date.
With the radio clock active, the time change is shifted by the value set under code 30 (time zone).
Note 3: If the radio clock is not active or not present, the time change always takes place at 03:00 on the Sunday before the set date.
With the radio clock active, the time change is shifted by the value set under code 30 (time zone).
3 Function
check
a)
Check the display. If there is no display, check the batteries
b)
“Continuously Comfort mode“
, read the temperature displayed
c)
Set the temperature setpoint to its maximum (refer to operating
instructions)
d)
The controller must deliver an OPEN signal
for about 150
seconds and the actuating device must travel to the fully open
position. If not:
·
Check actuating device and wiring
·
The room temperature is possibly higher than the adjusted
temperature setpoint
e)
Select operating mode “Frost protection“
f)
The controller must deliver a CLOSE signal
for about 150
seconds and the actuating device must travel to the fully closed
position. If not:
·
Check actuating device and wiring
·
Room temperature may be lower than 8 °C (16 °C with setpoint
limitation)
g)
Set temperature setpoint of “Continuously Comfort mode“
to the
required level
h)
Select the required operating mode
4 Reset
User-defined settings:
Press simultaneously
,
and
for 3 seconds:
All temperature and time settings of the slider positions are reset to
their default values (refer to section “Factory settings“ in the operating
instructions). The settings made on the expert level will remain
unchanged.
The clock starts at 12:00, the date on 01-01-08
(01 – January - 2008). During the reset time, all sectors of the display
are illuminated and can thus be checked.
All user-defined settings plus those made on the expert level:
Press simultaneously the DIP switch reset button,
and
for 5
seconds:
After this reset,
all factory settings
will be reloaded. This applies to
both the slider settings and the settings made on the expert level.
Notes
·
The REV34.. is an electronic room temperature controller with 7-
day time switch
·
The controller is classified as a device of software class A and
designed for use in environments with normal degree of pollution
·
The remote control contact must be wired separately, using a
screened cable
DE
EN
FR
IT
NL
ES
PT
CS
HU
PL
SV
FI
DA
TR
EL
