Siemens RB500, Руководство по установке

Страница: 15 / 36

RB500 Installation Guide 15
ENG
A Power in, terminal nos 1(+) and 2. 12-24 Vdc.
B Terminal block 4 is used for preconfigured inter-
face A3.
See table of connections for 2010 system.
C Terminal blocks 5, 7, 8, 9 & 10 can be used in
preset configuration A3. See table of connections
2010 system.
D Set to ENTRY for Bewator 2010 Omnis.
E
For Bewator 2010 Omnis following jumpers are
used:
EXT = The tamper status signal exists on 11 & 12.
Both jumpers must be placed in the same posi-
tions.
F
Selection of logic for tamper switch.
NC= Closed when the housing is closed.
Default: NC.
G Tamper switch connection, terminal nos 11 and
12.
H For Bewator 2010 Omnis following jumper is used:
10K = Embedded resistor 10 kohm connected in
serial with tamper switch for connection of
tamper monitoring.
When using two readers, one of them is jumpered
on S/C .
See separate connection diagram for two RB500
(doc no 81803)
I Mechanical tamper switch.
J Buzzer.