Siemens LU60LAF24, Руководство пользователя и инструкции по установке

Страница: 12 / 20

en
Installation instructions
12
11.8 Instructions for the exhaust air pipe
The appliance manufacturer does not provide any war-
ranty for faults attributable to the pipeline.
¡
Use a short, straight exhaust air pipe with as large a
pipe diameter as possible.
¡
Long, rough exhaust air pipes, many pipe bends or
small pipe diameters reduce the suction power and
increase the fan noise.
¡
Use an exhaust pipe that is made of non-combust-
ible material.
¡
To prevent condensate from returning, fit the ex-
haust pipe with a 1° gradient from the appliance.
11.9 Instructions for the air extraction mode
For air extraction mode, a one-way flap should be in-
stalled.
Notes
¡
If a one-way flap is not included with the appliance,
one can be ordered from a specialist retailer.
¡
If the exhaust air is conveyed through the external
wall, a telescopic duct should be used.
11.10 Installation
Checking the unit
1.
Check whether the fitted unit is level and has suffi-
cient load-bearing capacity.
The max. weight of the appliance is 6 kg.
2.
Ensure that the fitted unit is heat-resistant up to
90 °C.
3.
Ensure that the fitted unit is still stable after the cut-
outs have been made.
Preparing the units
Requirement:
The unit is suitable for the installation.
→
"Checking the unit", Page 12
1.
Cover the hob to prevent damage.
2.
Ensure that the fitted unit is still stable after the cut-
outs have been made.
3.
Make the cut-out for the exhaust pipe.
4.
Remove any shavings.
Preparing the appliance
▶
Remove the grease filters.
To avoid causing damage, do not bend the grease
filters.
Installing the appliance
1.
Insert the screws in the appliance.
2.
Hold the appliance at the bottom of the unit and
screw it firmly in place.
3.
Secure the exhaust pipe to the air pipe connector.
4.
Connect the exhaust pipe to the exhaust air opening
on the external air extraction system.
5.
Seal the joints.
6.
Insert the mains plug into the protective contact
socket.
7.
Fit the grease filters.
To avoid causing damage, do not bend the grease
filters.
8.
Close the holes with the plug.