6
Operating modes
This appliance can be used in exhaust-air mode or circulating-
air mode.
Exhaust air mode
Note.
The exhaust air must not be conveyed into a functioning
smoke or exhaust gas flue or into a shaft which is used to
ventilate installation rooms which contain heat-producing
appliances.
■
Before conveying the exhaust air into a non-functioning
smoke or exhaust gas flue, obtain the consent of the heating
engineer responsible.
■
If the exhaust air is conveyed through the outer wall, a
telescopic wall box should be used.
Circulating-air mode
Note:
To bind odours in circulating-air mode, you must install
an activated carbon filter. The different options for operating the
appliance in circulating-air mode can be found in the brochure.
Alternatively, ask your dealer. The required accessories are
available from specialist outlets, from customer service or from
the Online Shop. The accessory numbers can be found at the
end of the instructions for use.
Operating the appliance
These instructions apply to several appliance variants. It is
possible that individual features are described which do not
apply to your appliance.
Note:
Switch on the extractor hood when you start cooking and
switch it off again several minutes after you have finished
cooking. This is the most effective way of removing the kitchen
fumes.
Control panel
Setting the fan
Note:
Always adjust the fan strength to meet current conditions.
If there is a large build-up of steam or fumes, select a high fan
setting.
Switching on the appliance
1.
Press the
#
button.
Fan setting 1 is set.
2.
Press the
a
button until the required fan setting is set.
The set fan setting is shown in the display panel. After the
intensive setting, fan setting 1 is set.
Switching off the appliance
Press the 0 button.
Intensive setting
You can use the intensive setting if there is a large build-up of
odours and fumes/vapours.
1.
Press the
a
button until fan setting 4 is displayed in the
display panel.
The intensive setting is activated.
2.
Press the
a
button until fan setting 1 is displayed in the
display panel.
The intensive setting is deactivated and fan setting 1 is set.
Note:
The running time of the intensive setting is 5 minutes.
Once this time has elapsed, the appliance switches back to fan
setting 2.
Fan run-on time
The duration of the run-on time depends on the fan setting that
is set:
■
Fan setting 1: 20 minutes
■
Fan setting 2: 15 minutes
■
Fan setting 3: 10 minutes
■
Intensive setting: 5 minutes
1.
Select the fan setting.
2.
Press the
x
button.
The fan runs at the set fan setting. The indicator beside the
set fan setting flashes. The ventilation automatically switches
off once the run-on time has elapsed.
3.
Press the
a
button.
The fan run-on ends before the remaining run-on time
elapses. Ventilation continues at the set fan setting.
4.
Press the
x
or
#
button.
The fan run-on ends before the remaining run-on time
elapses. The ventilation is switched off.
The air which is drawn in is cleaned by the
grease filters and conveyed to the exterior
by a pipe system.
The air which is drawn in is cleaned by the
grease filters and an activated carbon filter and
conveyed back into the kitchen.
Explanation
1
Switch the fan on/off
2
Switch the fan setting up
3
Display panel
4
Switch on the lighting
5
Switch on the fan run-on
Содержание LC66HA241T
Страница 2: ......
