Siemens KG36NHI32, Руководство пользователя

Страница: 50 / 138

en
Faults – what to do?
50
3
Faults – what to do?
Faults – what to d o?
Before you call customer service, use this table to check whether you can rectify the
fault yourself.
Temperature differs greatly from the set value.
Switch off appliance for 5 minutes.
~
"Switching off and disconnecting the appliance"
on page 37
If the temperature is too warm, check temperature
again after a couple of hours.
If the temperature is too cold, check temperature
again on the following day.
Displays do not illuminate.
The mains plug has not been inserted properly. Connect the mains plug.
The fuse has tripped. Check the fuses.
The power has failed. Check whether the power is on.
Display flashes.
The temperature in the freezer compartment was
too warm.
When button “alarm” has been pressed, the warm-
est temperature reached in the freezer compartment
is displayed for 5 seconds. Press the “alarm” but-
ton. The display stops flashing.
Appliance is not cooling, display and light are lit.
Demo mode switched on. Hold down button “alarm” for 10 seconds until an
acknowledgement signal sounds. Wait and check
whether the appliance is cooling.
Display flashes, warning signal sounds and button “alarm” is lit.
Press the “alarm” button. Alarm is switched off.
Appliance door is open. Close the appliance door.
Ventilation openings have been covered. Clear ventilation openings.
Large quantities of fresh food were placed in the
appliance.
Do not exceed max. freezing capacity.