Siemens iQ700 ER6A PD7 Series, Инструкция по эксплуатации

Страница: 5 / 16

Getting to know your appliance
en
5
■
Operating a burner with the power set too
high will result in very high temperatures
being generated. This may cause
flammable materials to ignite. The power
setting shown in the display may differ from
the power setting that has been set using
the knob. The power setting is shown in the
display purely for additional information.
Always set the power setting according to
the printing on the knob.
:
Warning – Risk of injury!
■
Cracks or fractures in the glass plate are
dangerous. Shut immediately off all burners
and any electrical heating element. Unplug
the appliance from the mains or switch off
the circuit breaker in the fuse box. Shut off
the gas supply. Do not touch the appliance
surface. Never switch on a faulty appliance.
Contact the after-sales service.
Risk of injuries!
■
Pans which are damaged, are not the right
size, hang over the edge of the hob or are
not positioned correctly can cause serious
injuries. Follow the advice and warnings
provided relating to the cooking pans.
Risk of injuries!
■
In the event of a malfunction, turn off the
appliance’s gas and electricity supply. For
repairs, call our Technical Assistance
Service.
Risk of injuries!
■
Do not tamper with the appliance's interior.
If necessary, call our Technical Assistance
Service.
Risk of injury!
■
If a control knob is too stiff to turn or it is
loose, it must not be used. Contact our
after-sales service immediately to have the
control knob repaired or replaced.
:
Warning – Risk of electric shock!
■
Do not clean the appliance using steam
cleaners.
Risk of electric shock!
■
Cracks or fractures in the glass plate could
cause electric shocks. Switch off the circuit
breaker in the fuse box. Contact the after-
sales service.
*
Getting to know your
appliance
Getting to know your appliance
You can find your appliance and the burner powers in
the model overview.
~
Page 2
Controls and burners
Each control knob is marked with the burner it controls.
You can use the control knobs to set the output
required in each case to various positions between the
maximum and the minimum settings. Never try to switch
directly from position 0 to position 1 or from position 1
to position 0.
For dual double-flame burners, the inner and outer
flames can be controlled separately. The available
power levels are as follows:
Indicators
¼
Burner controlled by control knob
Ú
Switched-off burner
9 Highest power setting and electric ignition
1 Lowest power setting
Displays
³
Electric ignition
Š - ‚
Heat settings
‹
Switched-off burner
• - œ
Residual heat
Inner and outer flame on
full power.
Outer flame on low power,
inner flame on full power.
Inner flame on full power.