Siemens HydroRanger 200 HMI, Руководство по эксплуатации, Страница: 55 / 404

Commissioning
6.3 RUN mode
HydroRanger 200 HMI
Operating Instructions, 06/2018, A5E36281317-AC
53
6.3.2 Display field descriptions
Display field Description
Tag A short description that can be set using parameter Tag (3.1.1.) (Page 252)
Primary Reading
type
Identifies the type of measurement shown in the Primary Reading field.
Primary Reading Displays the value of the Primary Reading. This value is selected by using a
Quick Start Wizard or Sensor mode (2.1.3.) (Page 163). For more information
on how to select a value, see Operating (Page 91).
Point Identifier Level Point number for data currently displayed. For more information on
measurement view scrolling, see Auxiliary reading (Page 54).
Current View Num-
ber
Displays the number of the Measurement View (1 or 2).
Primary Reading
Units
The measurement of units corresponding to the Primary Reading. The field will
be blank if the Primary Reading has no units.
Level Alarm Status
(high/low)
Show the Hi/Hi-Hi and Lo/Lo-Lo level alarm statuses. Will display if one or
more relays have been programmed for level alarms. For information about
programming level alarms, see parameter Relay function (2.8.1.4.) (Page 195).
Level Bar Graph Bar graph indicator that visually represents the level of the Point being dis-
played
Filling/Emptying Indicates if the level is rising or falling. For information about programming, see
Emptying indicator (2.3.10.) (Page 176) and Filling indicator (2.3.9.)
(Page 176).
Discrete Inputs
(active/inactive)
Displays information about which discrete inputs are programmed and the
current state of each input. Discrete inputs are used to trigger or alter the way
the device controls other devices such as pumps and alarms.
Relays Information about which relays are programmed and what the current states of
each relay are.
Fault Text If there is a fault, this displays the description of the active fault. If there is no
fault, the field will appear blank.
Fault Number If there is an active fault, this field displays the number of the fault. For descrip-
tions of possible faults, see General fault codes (Page 282).
Device Status Indi-
cator
If two faults are present at the same time, the device status indicator and text
for the highest priority will display.
Fault Point The point number (1 or 2) of the fault.
Auxiliary Reading
Units
The measurement units corresponding to the Auxiliary Reading. The field will
appear blank if the Auxiliary Reading has no units.
Auxiliary Reading Displays the value of the Auxiliary Reading. The value shown here is selected
using Default auxiliary reading (2.12.7.) (Page 239). For more information on
how to select the value display, see Auxiliary reading (Page 54).
Auxiliary Reading
Name
Identifies the value shown in the Auxiliary Reading field.