Siemens HP243 26M Series, Инструкция по эксплуатации

Страница: 12 / 24

12
Setting procedure for the lower gas burner
Example in the picture: Heat at 270 °C
1.
Open the top cover. The top cover must remain open for as
long as the oven is in operation.
2.
Open the main gas supply to the appliance. Connect the plug
in the socket. Open the oven door.
3.
Push in the switch for the lower gas burner and turn it to
270 °C.
4.
While holding the switch for the oven's lower gas burner
depressed, press the ignition button 8 .
5.
The gas escaping from the oven's lower gas burner is ignited
using the ignition button. To activate the safety pilot, press
and hold the lower gas burner on the oven for 10 seconds.
6.
Look through the inspection port to make sure that the flame
is lit. If it is not, repeat the process from step 3.
7.
Close the oven door slowly.
8.
Turn off the switch for the lower gas burner after 30 minutes.
Procedure for setting the gas grill
1.
Open the top cover. The top cover must remain open for as
long as the oven is in operation.
2.
Turn on the main gas supply to the appliance. Connect the
plug to the socket.
3.
Insert the protecting plate into the groove under the control
panel.
The protecting plate is inserted with the longer edge facing
forwards and the curvature facing downwards.
Fasten the protecting plate in the groove under the control
panel using the retainers.
Make sure that the protecting plate is latched into the
retainers. Once the protecting plate cannot be removed, it is
correctly latched in place. You can now safely use the
protecting plate. If it can be removed, insert it into the groove
at a slightly higher angle and make sure that it latches into
the retainers.
4.
Close the oven door so that it is in contact with the protecting
plate.
5.
Press the function selector and turn it clockwise to the grill
setting # .
6.
Keep the function selector pressed in and simultaneously
press the ignition button 8 .
7.
The gas leaving the gas grill is ignited using the ignition
button. To ensure that the ignition safety system responds,
press and hold the function selector for 10 seconds.
8.
Check whether the flame is lit. If the flame is not lit, repeat the
process from step 5.
9.
Switch off the function selector after 30 minutes. Once the
oven has cooled down, remove the protecting plate.
Caution!
The gas grill only works when the protecting plate is inserted.
Make sure that the protecting plate is correctly inserted.
Cleaning the accessories
Before you use the accessories for the first time, clean them
thoroughly with hot soapy water and a soft dish cloth.
Advance cleaning of burner cup and cap
Clean the burner cap (1) and cup (2) with water and washing-
up liquid. Dry the individual parts carefully.
Place the burner cup and cap back on the burner shell (5).
Ensure that the igniter (3) and flame safety pin (4) are not
damaged.
The nozzle (6) must be dry and clean. Always position the
burner cap exactly over the burner cup.