Basic operation
en
15
Setting
Water hardness in
mmol/l
German hardness °dH
French hardness °fH
1 (soft)
Up to 1.5
Up to 8.4
Up to 15
2 (medium)
1.5-2.5
8.4-14
15-25
3 (hard)
2.5-3.8
14-21.3
25-38
4 (very hard)
2
Above 3.8
Above 21.3
Above 38
1
Only set this if you will be using solely softened water.
2
Also set for mineral water. Only use non-carbonated mineral water.
7.2 Performing initial start-up
After connecting the appliance to the power supply,
you must configure the settings for its initial start-up.
Note:
You can also use the Home Connect app to con-
figure the settings. If your appliance is connected, fol-
low the instructions in the app.
1.
Press to switch the appliance on.
a
The first setting appears.
2.
If required, change the setting.
Possible settings:
– Language
– Time
– Date
– Water hardness
3.
Use
to switch to the next setting.
4.
Work through the settings and make changes as re-
quired.
a
After the last setting, a note appears on the display
confirming that the initial start-up is complete.
5.
To check the appliance before heating for the first
time, open and close the appliance door once.
7.3 Cleaning the appliance before using it
for the first time
Before using the appliance to cook food for the first
time, you must clean the cooking compartment and ac-
cessories.
1.
Remove the product information and the accessor-
ies from the cooking compartment. Remove any
leftover packaging, such as polystyrene pellets, and
any adhesive tape either in or on the appliance.
2.
Wipe the smooth surfaces in the cooking compart-
ment with a soft, damp cloth.
3.
Press to switch the appliance on.
4.
Fill the water tank.
→
"Filling the water tank", Page 18
5.
Apply the following settings:
Type of heating
4D hot air
Temperature
Maximum
Added steam
03
Cooking time
1 hour
6.
Start the operation.
‒
Ventilate the kitchen while the appliance is heat-
ing.
a
Once the cooking time has elapsed, a signal tone
sounds. A note appears on the display confirming
that the operation has finished.
7.
Press to switch the appliance off.
8.
Once the appliance has cooled down, clean the
smooth surfaces in the cooking compartment with a
detergent solution and a dish cloth.
9.
Clean the accessories thoroughly using a detergent
solution and a dish cloth or soft brush.
10.
Empty the water tank and dry the cooking compart-
ment.
→
"After using steam operation", Page 20
8 Basic operation
8.1 Switching on the appliance
▶
Press to switch the appliance on.
a
The display shows the menu.
8.2 Switching off the appliance
Switch your appliance off when you are not using it.
The appliance automatically switches itself off if it is not
used for a certain period of time.
▶
Press to switch the appliance off.
a
The appliance switches off. Any functions currently
in progress are cancelled.
a
The time or residual heat indicator appears on the
display.
8.3 Starting the operation
You must start each operation.
ATTENTION!
If there is water on the cooking compartment floor
when operating the appliance at temperatures above
120 °C, this will damage the enamel.
▶
Do not use the appliance if there is water on the
cooking compartment floor.
▶
Wipe away any water on the cooking compartment
floor before operation.
▶
Use "Start" to start the operation.
a
The settings appear on the display.
