Siemens HiPath 1120, Руководство по программированию

Страница: 96 / 180

Step by Step
General Programming
96
Required: Programming Mode must be active (*95
31994).
Enter the code for programming.
or Activate/Deactivate remote configuration:
= To deactivate remote configuration
= To deactivate remote configuration
Initial state for Programming Mode.
Replace the handset.
Required: Remote Configuration must be enabled and
the programming extension must have a conversation
in progress on the external line that will be used for the
remote configuration.
With a conversation in progress enter the programming
extension code to transfer control of the HiPath 1100 to
the remote programmer.
The remote programmer must now enter the system
password using an MF telephone (default - 31994).
Wait for a confirmation tone to indicate that the
password was accepted.
To set the required configuration, proceed as if the
remote telephone was directly connected to the
system.
If a Fax/DID Module is Installed.
If the HiPath 1100 is equipped with a Fax/DID module
configured to answer external lines.
Enter the code using a remote MF telephone after the
call is answered.
The remote programmer must now enter the system
password using an MF telephone (default - 31994).
Wait for a confirmation tone to indicate that the
password was accepted.
To set the required configuration, proceed as if the
remote telephone was directly connected to the
system.
5 7
* #
*
#
*
9 9 1
* 9 5