Siemens Gigaset SL400H, Руководство пользователя

Страница: 12 / 45

11
First steps
Gigaset SL400H / IM1 EN (IRL_UK) / A31008-M2152-R101-1-4N19 / starting.fm / 02.02.2010
V
e
rsion 4,1, 21
.11.2007
First battery charge and discharge
The correct charge status can only be displayed once the battery is first fully
charged
and discharged.
Display in idle status
Once the phone is registered and the time set, the idle status is shown as in this
example.
Displays
u
Reception between the base and the handset:
– Good to poor:
Ð i Ñ Ò
– No reception:
|
flashes
Green : Eco Mode (
¢
page 22)
u
Battery charge status:
–
{
white: charged over 66%
–
{
white: charged between 33% and 66%
–
y
white: charged between 10% and 33%
–
y
red: charged below 10%
–
y
flashes red: battery almost empty (less than 10-minutes talktime)
–
x y xy x { x{
white: battery charging
¤
Place the handset in the charger for three
hours.
¤
Once the battery is
fully charged, remove
the handset from the
charger and do not
put it back again until
the battery is fully dis-
charged.
3hours
Please note
u
After the first battery charge and discharge, you may place your handset in
the charger after every call.
u
Always repeat the charging and discharging procedure if you remove the
battery from the handset and reinsert it.
u
The battery may heat up during charging. This is not dangerous.
u
After a time, the charge capacity of the battery will decrease for technical
reasons.
i V
07:15
INT 1 04 Apr
Calls Calendar