27
First steps
DL500A/DX600A-ISDN/DX800A / GRC EN / A31008-N3101-T101-1-8U43 / starting.fm / 27.10.10
V
e
rsion 4, 16.0
9
.2005
Then "
Register a handset?
" is shown in the display again (see above/page 26).
¤
Press the display key
§Yes§
if you wish to register another handset and perform
the steps listed above with this additional handset.
Press
§No§
to close the registration wizard and start the connection wizard.
4. Connection wizard
Using the connection wizard, you can assign the previously configured connec-
tions to the internal parties as receive or, if applicable, as send connections. Internal
parties are the base, the registered handset, the answering machine of the base and
the connected FAX device, if applicable.
u
Receive connections
are numbers on which you can be called. Incoming calls
are only diverted to those internal parties (end devices) for whom the associated
connection is assigned as a receive connection.
u
Send connections
are the numbers that are sent to the called party. The net-
work provider calculates charges based on the send connections. You can assign
each internal party a number or the associated connection as a send connec-
tion.
u
Each connection (number) of your phone can be both a send as well as a receive
connection. You can assign each connection to several internal parties as a send
and/or receive connection. It may only be assigned to an answering machine as
a receive connection.
Standard assignment
All connections of the base are assigned as receive connections to the base, the reg-
istered handsets and the local answering machine 1 at registration/start-up.
When the phone is connected to the ISDN, the first MSN in the configuration
(standard name
MSN1
) is assigned to the devices as a send connection. If no MSNs
are configured, the main number of the ISDN connection is used.
If the Gigaset DX800A all in one is connected to the analogue fixed line, the fixed
line number is assigned to the devices as a send connection.
Please note
u
By default, the base is assigned the internal name
INT 1
and the internal
number 1.
u
The base assigns the lowest free internal number to the handset
(possible numbers: 2–7). The handset's internal name is shown in the display
e.g.,
INT 2
. This means that the handset has been assigned the internal
number
2
.
u
The internal numbers and names can be changed.
Is started on
Gigaset DX800A all-in-one
and
Gigaset DX600A ISDN
.
