7
Gigaset A140
/ SING / A31008-M1643-Y201-1-7619 / Wyoming.fm / 27.09.2004
Appendix
Character set chart
Press the required key the number of times indi-
cated.
Specifications
Power consumption
In ready status: approx. 2 Watt. During charging:
approx. 3 Watt. During a call: approx. 2 Watt.
General specifications
Care
Wipe the base station and handset with a
damp
cloth
or an antistatic wipe.
Never
use a dry cloth!
This can cause static!
Contact with liquid
If the handset has come into contact with liquid:
1
Switch the handset off and remove the bat-
tery pack immediately
.
2 Allow the liquid to drain from the handset.
3 Pat all parts dry, then place the handset with
the battery compartment open and the keypad
facing down in a dry, warm place
for at least
72 hours
(
not
in a microwave, oven etc.).
4 Do not activate the handset again until it is
dry.
When it has fully dried out you will normally be
able to use it again.
Questions and answers
If you have any queries about the use of your tele-
phone, go to
www.siemens-mobile.com/gigasetcustomercare
for assistance 24/7. The table below contains a list
of common problems and possible solutions.
Service (Customer Care)
We offer you support that is fast and tailored to
your specific needs!
Our Online Support on the Internet:
www.siemens-mobile.com/gigasetcustomercare
For more information on aftersales service, please
refer to your local warranty card.
In some countries repair and replace services are
impossible where the products are not sold
through our authorised dealers.
1 x
2 x
3 x
4 x
5 x
6 x
Q
+
0
-
|
?
_
1
Space
1
R
# (appears in display as
j
)
P
*
/
(
)
,
Standard
DECT and GAP compatible
Range
up to 300 m outdoors, up to 50
m indoors
Mains unit
230 V ~/50 Hz
Operating tempe5 °C to +45 °C
Dimensions/Handset
154 x 54 x 30 mm (L × W × H)
Dimensions/Base
87 x 126 x 87mm (L x W x H)
Weight/Handset
approx. 127 g (including bat-
tery pack)
Weight/Base
approx. 121 g
Re-chargeable battery
pack
NiMH, 2xAAA Pack
Battery pack re-order
number
V30145-K1310-X359,
A5B00075178739
Battery pack capacity
550 mAh
Charging time
approx. 10 hours in base,
approx. 5 hours in desktop
charger
Calling time
approx. 10 hours
Standby time
approx. 170 hours (7 days)
Problem
Cause
Solution
Nothing
appears in the
display.
The handset is not
switched on.
Battery pack is
flat.
Press the end call
key
a
for
approx.
5 seconds
or place
the handset in the
base.
Charge/replace the
battery pack (page 2).
No response
to key press,
"
HOLD KEY"
appears in the
display.
The keypad lock is
activated.
Press the hash key
R
for
approx. 2 sec
No wireless
connection to
the base, dif-
ferent icons
flash in the
display.
The handset is
outside the range
of the base.
The handset is not
registered.
The base is not
switched on.
Cords not routed
correctly
Move the handset
closer to the base.
Register the handset
Check the power con-
nector at the base
Check cord routing
!
