5
Gigaset A140
/ SING / A31008-M1643-Y201-1-7619 / Wyoming.fm / 27.09.2004
Registering and de-registering
handsets
You can register up to four handsets on your base
station.
A Gigaset A14handset that is not yet registered on
a base is registered
automatically
. Other handsets
must be registered
manually
.
Automatic registering:
Gigaset handset A14
Any Gigaset A14handset that is not registered to a
base can be registered automatically. To register a
handset for the first time, place it in the base with
the
display facing forward
. Registering takes
about 1 minute; a number of icons flash in the dis-
play. The handset is
automatically
assigned the
next available internal number (1–4). This number
appears in the top left of the display after success-
ful registering, e.g. "2". If all of the internal num-
bers 1 to 4 are used up (i.e. four handsets have
been registered), handset number 4 is de-regis-
tered and overwritten.
Manual registering:
Gigaset handset A14
1. On the handset:
MENU
¢
REGISTER HS
¢
enter your system PIN (default is 0000)
¢
OK
.
The display shows
REGISTER HS
during the regis-
tration procedure.
2. On the base:
Within
60 sec.
of entering the sys-
tem PIN, press the register/paging key on the front
of the base (page 1) and
hold
for approx. 3 sec.
The registration process starts.
Manual registering: Other handsets
Other handsets are registered as follows:
1. On the handset:
Start to register your handset
as described in its operating instructions.
2. On the base:
Press the register/paging key
on
the front of the base (page 1) for approx. 3 sec.
The registration process starts.
De-registering handsets
You can de-register another handset from any reg-
istered Gigaset A14handset as follows:
INT
¢
Select handset
¢
MENU
¢
DE-REG H/SET
¢
OK
¢
Enter the system PIN (default is 0000)
¢
OK
¢
DE-REGISTER?
¢
OK
¢
a
.
The internal number disappears from the de-regis-
tered handset. Handsets that have not been de-
registered retain their internal number.
Using several handsets
Internal calls
Internal calls are no-cost calls to other handsets
that are registered to the same base.
Internal conference/Call connecting
You are in conversation with an
external
caller.
To confer:
INT
(the external party hears the wait melody)
¢
Select a handset
¢
c
(confer with internal
party).
End:
MENU
¢
GO BACK
¢
OK.
You are reconnected with the external caller.
Or to connect the call:
INT
¢
Select a handset
¢
c
(announce the
call if required)
¢
a
Press the end call key.
You can also press the end call key
a
immedi-
ately (without announcing the call). If the internal
party does not answer or is busy the call will come
back to you automatically.
INT
Press the display key.
Your own handset is marked "<".
either ...
Call a single handset:
~
Enter number of handset,
e.g.
2
.
or ...
Calling all handsets:
P
Press the star key.
... then
Ending the call:
a
Press the end call key.
