Siemens Gigaset 4010 Micro, Руководство по обслуживанию

Страница: 4 / 22

3 Service procedures
3.1 Service procedures for Gigaset 4000 micro
Note: The service procedures are confidential.
Reset, Displaytest, Software-Version & IPUI, Speechpath test and Metering mode:
The items QS-Data,Batt mode and DSP parameters have been implemented for
development and production purposes and are not needed in service.
3.2 Service procedures for Gigaset 4010/ 15 Micro base station
Note: For parameters X, Y, option see table below.
Press: "menu-key", 8, 9, X, 76200 (only if X=3 or 4), Y, select option, o.k.
A pos. acknowledge (rising sequence of notes) indicates that the procedure has
been accepted.
microphone to earphone
into the microphone).
off the handset. Now you
Speechpath test
SW-Version, IPUI
Metering mode
press menu key to switch
can see radio parameters
Switch a direct loop from
(check the path by blowing
Read out software version
and the IPUI number
Press “o.k.” to tick it and
during normal usage ***
*** example: 98 - 9 - 04 - 096 - 100
RX - Level
Frequency (0...9)
Time slot (0...11)
Base station code
bit error rate
100 = 100% o. k.
press 1, 4 and 7 simultaneously
and keep pressed
switch on and keep pressed until display testpattern is visible, then release all
keys
press 76200
Press 4685463
Same as entering: "HOTLINE"
This code generates a fundamental
reset on the handset. All settings are
reset to factory defaults (Tel.book,
network provider list and list of
incoming/ missed calls). Handset is
still registered to base.