Document No. 563-002
Installation Instructions
October 1, 2005
24 V-AC
C
E
H
C H
DO 1 DO 2 DO 3 DO 4 DO 5
NO C NO C NO C NO C NO C
DO 6 DI 3 DI 2
FLN
TRUNK
NO C AI 3
TX RX + - S BST
RTS
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16
WL
AN0004R1
TEC Power
(From Transformer)
TEC
(Typical)
Channel
Network I.D.
24 Vac 1.2 VA
24 Vac
Power Line
18 (457)
Maximum
Alternate
Power
3M Scotchlok
TM
Power Connectors (Typical of 2)
1. Thread TEC power
wire through
connector.
2. Fold up flap to
lock TEC wire
into connector.
3. Insert power wire
from TTX into
connector so it
appears in window.
4. Use lineman’s
pliers to pinch
connecting bar in
place and connect
wires internally.
5. Close connector
cover to secure
wires.
TEC
Power Wire
TTX
Power Wire
Figure 4.
FLNX Communication and Power Wiring.
5.
For Remote Mount Antenna:
Locate the liquid
tight
fi
tting so that the antenna extension cable
does not incur excessive pull force. At the desired
enclosure location, punch a 1/2” knockout and
use the locknut to secure the body of the liquid
tight
fi
tting into the knockout.
6.
For Remote Mount Antenna:
Route the
antenna through the body of the liquid tight
fi
tting
(Figure 5). Hand-tighten the liquid tight
fi
tting nut
to secure the antenna in place.
Make certain the liquid tight
fi
tting nut
tightens on the antenna base (Figure 5)
and not the antenna so that the antenna
can be articulated.
7. Connect the antenna wire to the FLNX.
8. Position the antenna in a vertical orientation (up
or down).
CAUTION:
For Factory installations
: The antenna
must be protected during shipment to avoid
damage to the antenna.
The installation is complete.
WL
AN0005R1
Liquid Tight Fitting
Installed in
Enclosure Knockout
Liquid Tight Fitting
Threaded Body
Antenna
Base
Antenna
Liquid Tight Fitting Locknut
Antenna Cable 12 inches
(305 millimeters)
Liquid Tight
Fitting Nut
Figure 5.
Remote mount antenna.
Siemens Building Technologies, Inc.
Page 3 of 4
