Siemens ER74232HK, Инструкция по установке и эксплуатации

Страница: 24 / 28

21
Sometimes certain faults detected can be easily resolved.
Before calling the Technical Assistance Service, bear in mind
the following advice:
If the faults continue / reoccur, please turn off the gas valve and contact our Customer Care Hotlines.
Faults
Symptom
Ignition electrode does not
spark
Electrical source
The source not installed,
poor contact Contact our Customer Care
Hotlines
Re-install correctly
Use a dry, soft cloth to dry
the ignition electrode
gnite again and hold the
knob down for 3-5 seconds
after the flame has ignited
Ensure the gas valve is
fully open
Re-install these
components correctly
Clean the dirt out of the
burner holes
Dry the ignition electrode
and remove any dirt
Contact our Customer Care
Hotlines
Switch on electrical source
Re-install correctly
Contact our Customer Care
Hotlines
Call our Customer Care
Hotlines
Not installed properly
The ignition is wet,
especially in the rainy
season; or due to food
overflows
The pressing and holding
time was too short for the
safety solenoid valve to
work properly
Not open or not completely
open
Caps or other components
are not installed correctly
The burner holes on the
cap are blocked so that
the gas can not flow out
normally
It is wet, or dirty due to the
overflowing food
The protection sensor is
dirty
Was shut off
Not installed properly
The gas rubber hose is
aging, cracked, fractured or
falling off
The main burner is not
igniting
Burner
Ignition electrode
Safety valve
Gas valve
Burner
Burner
Ignition electrode
Thermal couple
Electrical source
Cap
Leakage
Flame goes out when the
ignition knob is released
When you are using the
pulse ignition, the hob is
not ignited or has difficulty
igniting
Flame out when using
Unstable burning
Smell
Cause Solution