Siemens EH9..SZ1 series, Инструкция по эксплуатации

Страница: 12 / 16

12
Accessing the basic settings
The hob should be turned off.
1.
Turn on the hob with the main switch.
2.
Within the next 10 seconds, press the
0
symbol
for 4 seconds.
™‚ y is displayed on the left of the screen and ‹ on the right.
3.
Press the 0 symbol several times until the indicator for the
desired function appears on the left of the screen.
4.
Then select the desired setting on the programming panel.
5.
Press the 0 symbol again for more than 4 seconds.
The settings will have been correctly saved.
Quit
To leave the basic settings, turn off the hob at the main switch.
Care and cleaning
The advice and warnings contained in this section aim to guide
you in cleaning and maintaining the hob, so that it is kept in the
best possible condition
Hob
Cleaning
Clean the hob after each use. This prevents food remains left
on the surface from burning. Wait until the hob is cold enough
before attempting to clean it.
Only use cleaning products specifically designed for glass-
ceramic hobs. Follow the instructions provided on the
packaging.
Do not use:
■
Abrasive products
■
heavy-duty cleaners, like oven sprays and stain removers
■
Pads that may scratch
■
High-pressure or steam cleaners
Glass scraper
Remove dried-on food remains using a glass scraper.
1.
Release the scraper safety catch
2.
Use the blade to clean the hob surface
Do not attempt to clean the hob surface with the base of the
scraper. This could result in scratching.
ã=
Risk of injury!!
The blade is extremely sharp. Risk of cuts. Protect the blade
when not in use. Replace the blade immediately when any
imperfections are found.
Care of the appliance
Apply an additive to protect and preserve the hob. Follow the
advice and warnings provided with the product.
Hob frame
In order to avoid damage to the hob frame, follow the
indications below:
■
Use only slightly soapy hot water
■
Do not use sharp or abrasive products
■
Do not use a glass scraper
™‹
Return to basic settings
‹ Personal settings.*
‚
Return to factory settings.
Indicator Function
*Factory settings