Siemens EH8 BE15 Series, Инструкция по применению

Страница: 8 / 24

en
Operating modes
8
5.5 Distribution of the cooking zones
The specified power has been measured with the
standard pots, which are described in IEC/EN
60335-2-6. The power may vary depending on the size
of the cookware or cookware material.
B
A A
B
Area Highest power level
​⁠ 21 cm dia-
meter
Power level 9
powerBoost
2200 W
3700 W
Area Highest power level
​⁠ 18 cm dia-
meter
Power level 9
powerBoost
1800 W
3100 W
5.6 Cooking zone
Before you start cooking, check whether the size of the
cookware fits the cooking zone that you want to use for
cooking:
Area Cooking zone type
​⁠ Single-circuit cooking zone
5.7 Residual heat indicator
The hob has a residual heat indicator for each cooking
zone. Do not touch the cooking zone if the residual
heat indicator is lit.
Display Meaning
​⁠ The cooking zone is hot.
​⁠ The cooking zone is warm.
6 Operating modes
You can use your appliance in air extraction mode or
circulating-air mode.
6.1 Air extraction mode
The air which is drawn in is cleaned by the grease fil-
ters and conveyed to the exterior by a pipe system.
The air must not be discharged into a
flue that is used for exhausting fumes
from appliances burning gas or other
fuels (not applicable to appliances that
only discharge the air back into the
room).
¡
If the exhaust air is to be conveyed
into a non-functioning smoke or ex-
haust gas flue, you must obtain the
consent of the heating engineer re-
sponsible.
¡
If the exhaust air is conveyed
through the external wall, a tele-
scopic duct should be used.
6.2 Air recirculation mode
The air which is drawn in is cleaned by the grease fil-
ters and an odour filter, and conveyed back into the
room.
To bind odours in circulating-air mode,
you must install an odour filter. The dif-
ferent options for operating the appli-
ance in circulating-air mode can be
found in our catalogue. Alternatively,
ask your dealer. The required accessor-
ies are available from specialist retail-
ers, from customer service or from the
Online Shop.
7 Before using for the first time
Observe the following recommendations.
7.1 Preparing the appliance
To ensure correct operation, you must arrange the
components in this order:
1.
Insert the filter.
2. Insert the metal grease filter.
Note:
Never operate the appliance without the metal
grease filter and the overflow container.
7.2 Setting the operating mode
The appliance is supplied with a preset circulating-air
mode.
When your hob is installed with an air outlet to the out-
side, you must configure the setting ​⁠ ​⁠ ​⁠ to this mode.
You can find additional information about this in the
section entitled
→ "Basic settings", Page 12