206_58300000105199_ara_en_h – 15.03.a
Seite 54 von 66
2
Sensor too much sensitive
3
Out of tolerance
4
Problem with the start key
9
Activation at the same time of some sensors.
Once, allof the sensors have been checked and if theses ones work
properly, the program go automatically to the buzzer and displays
checking.
For this, the buzzer is activated for 2 sg and all the leds and segments
are iluminated for 10 sg.
Step P2: Setting the defaults for the TC
The P2 menu makes it possible to set the defaults for the TC
•
Fictitious residual-heat indication „H/h“ deleted.
•
Data for Memory deleted, set default.
•
Buzzer Off not set
•
Reduced Key lock time not set
•
Child lock not activated
The steps are as follows:
1. Press any key except power key.
2. A Beep sounds.
3. to signalize the sert defaults, all displays show „oooo“ for 2
sec. After that, the Tc leaves the service mode and goes
into stand by mode
