Siemens DMS8000 MP4 Series, Руководство по установке и настройке

Страница: 11 / 15

Configuration
Configuration checklist
5
11
Building Technologies A6V10067796_a_en
Fire Safety & Security Products 30.06.2013
5 Configuration
5.1 Configuration checklist
Verify that you have satisfied the items needed in the first checklist before proceeding
to the configuration checklist that follows.
Items Needed For Configuration

The MultiScope model and variant, i.e. the number of video inputs

The MultiScope parameter settings, including:
– Local address (0 to 99)
– IP address

The camera connections

Video application required for integrating Geutebrück MultiScope:
– Geutebrück Multiview

Plug-ins needed:
– #252101 (ST DV SIVMS/ST VD OPC)
– #353801 (OPCDVRST/OPC DVR ST)
Note: Plug-ins are installed during the software setup procedure. You can check that
the Plug-ins are actually available using the Composer Plug-in Installer in the
DMS8000 start menu.
Configuration overview
1. Add the Video Network Manager.
2. Add the folder for the MultiScope system.
3. Add the MultiScope node.
4. Configure the MultiScope variant and addresses.
5. Connect the cameras.
5.2 Configuration procedure
The following are the configuration procedures for a MultiScope unit:
Adding the Video Network Manager
1. Open the Composer project.
2. If not already done, add
- the Video Network Manager
- and the MultiScope driver.
Adding the folder for the MultiScope system

Optionally, create a folder for the MultiScope unit.