Siemens  dishwasher, Руководство по эксплуатации

Страница: 23 / 40

Operating the appliance en
23
1. Close the door.
2. Switch on ON/OFF switch
(
.
3. Hold down programme button
#
and press START button
h
until
•
:
‹
... is indicated on the digital
display.
4. Release both buttons.
The LED for button
#
flashes
and the digital display
)*
displays
the factory setting
•
:
‹…
.
5. Keep pressing programme
button
#
until the value
˜
:
‹
... is
indicated on the numerical display
)*
.
To change the setting:
1.
Press programme button
3
.
Each time the button is pressed,
the set value increases by one level;
when the value of
˜
:
‹ƒ
has been
reached, the display jumps back
to
˜
:
‹‹
.
2. Press START button
h
.
The set value is saved.
Switching off the appliance
Short time after the end of the
programme:
1. Switch off ON/OFF switch
(
.
2. Turn off the tap (not applicable if
Aqua-Stop fitted).
3. Remove the utensils when they have
cooled down.
Note
When the programme ends, leave
the appliance to cool down a while
before opening it. This will prevent
steam from escaping and causing long-
term damage to your built-in furniture.
In the case of the TurboSpeed 20 min.
programme switch off if no further rinse
cycle is to follow.
Interrupting the programme
1. Switch off ON/OFF switch
(
.
The LEDs go out. The programme is
saved.
If the door was opened on an
appliance which has a warm water
connection or is heated, first leave
the door ajar for several minutes and
then close. Otherwise, expansion
(pressure) may cause the appliance
door to spring open or water to run
out of the appliance.
2. To continue the programme, switch
on the ON/OFF switch
(
again.
Terminating the programme
Terminating the programme
(Reset)
1. Press START button
h
for
approx. 3 sec.
The numerical display
)*
indicates
‹
:
‹‚
.
2. The programme sequence lasts
approx. 1 min. On the digital
display
)*
is indicated
‹
:
‹‹
.
3. Switch off ON/OFF switch
(
.
Changing the programme
When the START button
h
has been
pressed, the programme cannot be
changed.
The only way a programme can be
changed is by Cancel programme
(Reset).