56
en
Tips on energy saving
■ Open the ground coffee drawer, drop in
a cleaning tablet and close the coffee
drawer again�
■ Remove the water filter (if there is one)
and press
C
■
Pour lukewarm water into the empty
water tank up to the “0�5 l” mark and then
dissolve one Siemens descaling tablet
TZ80002 in it�
F
If there is not enough descaling
solution in the water tank, you will
be asked to do the following. Refill
using uncarbonated water and press
C
again�
■ Remove the suction pipe from milk
container, wipe it and insert the end of the
suction pipe into the hole on the coffee
grounds container�
■
Close the appliance door�
■
Place a container with a capacity of
0�5 litre under the beverage outlet�
■
Press button
C
�
The programme will now run for about
19 minutes�
■ Remove the container and press
C
�
■ Rinse the water tank and (if removed)
replace the water filter.
■
Fill the tank with fresh water up to the
“max” indicator�
■ Replace the water tank and close the
door�
■
Place the container underneath the
beverage outlet again�
■
Press button
C
�
The programme will now run for about
7 minutes and rinse the appliance�
■ Remove the container, empty the drip
trays, replace and close the appliance
door�
■
Press
C
� The appliance is des-
caled, cleaned and ready for use again�
■
Press
E
to exit the program�
Special rinsing
F
Important:
If any of the service
programmes is ever interrupted, for
instance by a power failure, please
proceed according to the information
on the display:
■ Rinse the water tank and refill it with fresh
water up to the “max” mark�
■
Press button
C
� The pro-
gramme will now run for about 2 minutes
and rinse the appliance�
■
Empty the drip trays, replace and close
the appliance door� The appliance is
ready for use again�
■
Press
E
to exit the program�
Tips on energy saving
■
Press button
I
to switch the
appliance to “energy saving mode”� The
appliances uses very little power when
in “energy saving mode”, but monitors all
safety-relevant functions so as to avoid
damage�
■
In the menu under
“Switch off after”,
set the automatic switch off period to
15 minutes�
■ Reduce the brightness of the display
and the illumination in the menu to save
energy�
■
If possible, do not interrupt the dispensing
of coffee or milk froth. Stopping a process
prematurely results in higher energy
consumption and the drip tray fills up
more quickly�
■
Descale the appliance regularly to avoid a
build-up of limescale� Limescale residues
cause higher energy consumption�
Frost protection
To prevent frost damage during trans-
port and storage, completely empty the
appliance beforehand (see the section
“Menu – Frost protection”)�
www.devicemanuals.eu/
