NOTE:
You can press the OVERRIDE button on the receiver to manually switch ON/OFF for a faulty
room unit or transmission signal.
Front View Receiver
LED Signal Indicator
LED Relay Indicator
The signal is good when the
LED is solid green.
A solid red LED indicates that
there is no signal.
Orange LED indicates relay is on.
OVERRIDE Button *
* Note when OVERRIDE is
pressed, the RF signal will not
affect the output for 15 min
.
After 15 min the output and LED
will not change if no RF received.
If RF received, output and LED
will follow the RF data.
Press this button to manually switch on or
off
RESET: Press the LEARN & OVERRIDE
button for 4 seconds to delete all transmitter
addresses.
LEARN Button
Rear View Room Unit
(Transmitter)
Press the button to put into learn mode
Mounting plate must be
removed to get access
to the back!
Learn Button
TEST Button
Press to learn
Used for testing transmission.
Configuration instructions for the BOSS BRTRF
The Transmitter BRTRF room unit and the receiver BR1 are set to communicate (bonded) with each
other at the factory. If they fail to do so at installation or it is necessary to re bond the units due to loss of
communication please follow the following instructions.
1. If room unit is wall mounted remove from wall or if on table stand remove grey backing plate
2. For receiver Reset by simultaneously pressing the LEARN & OVERRIDE button for 4 seconds.
3. On Receiver Press and release the LEARN button. This puts the receiver in learn mode.
4. On room unit Press and release the LEARN button on the back. Green LED will flash on receiver
and come on solid after 20seconds
5. A green solid LED indicates a good signal, a red solid LED indicates no signal.
6. To test transmission, press the TEST button on the transmitter, this switches the relay to ON on
the receiver regardless of temperature. The RF TEST symbol appears on the display (1 s).
7. An orange LED indicates that the relay is on.
