Siemens 1LE5, Руководство по эксплуатации

Страница: 25 / 142

The ESD protective measures required for components that can be destroyed due to
electrostatic discharge are shown in the following drawings:
6HDWLQJSRVLWLRQ
6WDQGLQJSRVLWLRQ
6WDQGLQJVHDWLQJSRVLWLRQ
E E
D
F
D
I I I I I
D
F F
H
G G
H
G
a = conductive floor sur‐
face b = ESD table c = ESD shoes
d = ESD overall e = ESD wristband f = cabinet ground connection
2.7 Interference immunity
By selecting suitable signal cables and evaluation units, ensure that the interference immunity
of the machine is not diminished.
2.8 Influence on the line power supply through a strongly irregular
torque
A strongly irregular torque, for example with the drive of a reciprocating motor, forces a non-
sinusoidal motor current. The emerging harmonics can have an impermissible influence on the
line power supply via the connection lines.
2.9 Interference voltages when operating the converter
Interference voltages when operating the converter
When a converter is in operation, the emitted interference varies in strength depending on the
converter (manufacturer, type, interference suppression measures undertaken). On machines
with integrated sensors (e.g. PTC thermistors), interference voltages caused by the converter
may occur on the sensor lead. This can cause faults which can result in eventual or immediate
death, serious injury or material damage.
• Comply with the EMC information provided by the manufacturer of the converter. This is how
you prevent limit values according to IEC/EN 61000-6-2 .... IEC/EN 61000-6-4 for the drive
system (consisting of the machine and converter) from being exceeded.
• You must put appropriate EMC measures in place.
Safety information
2.9 Interference voltages when operating the converter
1LE5, 1PC4 shaft heights 280 ... 355
Operating Instructions, 11/2022, A5E41454666A
23