Mounting and Demounting
5
Mounting and Demounting
The device is mounted on a top hat rail.
Mounting
▸
Place the tilted device with its rear side on the top edge of the rail. The top hat rail in-
terlocks with the slot of the top device suspension (see left figure below). Now slew
the device to the upright position until the latch at the bottom device suspension is
locked.
Demounting
▸
Place a screw driver in the groove at the bottom device suspension as shown in the
right figure below. Move the screw driver upward so that the latch releases the top
hat rail. Then slew the device out of the top hat rail.
Fig. 4: Mounting and demounting the gateway 0362151
18
Gateway 0362151 - PROFIBUS to SERVOLINK 4 Connection
