SIEB & MEYER 036215, Руководство пользователя

Страница: 34 / 40

Technical data Rated value
Operating temperature -20 to 70 °C
Tensile stress Between optical fiber cable and connector 19.6 N
Optical fiber cable 49 N
Bending radius
(1) Min. 25 mm
(1) When bending the optical fiber cable to install it, note that the recommended bending radius is six to ten
times greater than the minimum bending radius.
Procedure
➮ Remove at least 7 mm of the optical fiber cable's plastic sheath (diameter 2.2
mm); see figure, [1]). Take care that the dismantled end of the optical fiber cable is
not contaminated. If necessary, clean it gently with a dry tissue paper.
➮ Insert the dismantled optical fiber cable carefully as shown in the figure into the
connector. The polymer fiber of 1 mm should stand out from the connector about 1
to 2 mm (see figure, [2]).
➮ Press the clip of connector so that the polymer fiber is hold in the connector. The
connector and the clip must interlock audibly (see figure, [3]).
➮ Insert the connector with the optical fiber cable into a polishing disk and grind the
outstanding end of the fiber by means of a polishing sheet on an even surface
(e.g. glass sheet), see figure, [4]). Remove grinding residues.
You can order the following materials at SIEB & MEYER:
Article SIEB & MEYER article number
Polishing disk for optical fiber cables 47000001
Dismantling tool for optical fiber cables 47000002
Grinding paper 47000003
6.2.3 X5 – JTAG Connector
Service interface for SIEB & MEYER
6-pole Mini-Combicon connector
6.2.4 X6 – USB Connector
Service interface for SIEB & MEYER
4-pole female USB connector, type B
Connectors, Switches and Displays
W
34 Gateway 0362151A - PROFIBUS to SERVOLINK 4 Safety
6