17
5488
7
2021
-
RCT 20U, 21U, 22U, 23U & REMOTE RECEIVER
MG_0200
Pair Button
Pair Button
Pair Button
Pair Button
Programming Additional Transmitters/ Remote Controls
EN
The original transmitter and receiver have the same factory pre-set code so that no programming is necessary. When additional transmitters
remote controls are to be used, the additional transmitters/remote controls have to be paired with the receiver.
1. Be sure there is power on the receiver (S-link status LED is blinking green or continuous green ) and the transmitter that should be paired is off .
2. Push the Pair Button on the receiver to put the receiver in pairing mode (as shown above). The LINK/ACT LED should start to blink.
3. Within 10s after the receiver pair button is pushed, set the transmitter in pairing mode by holding the off button and pressing both “ON” buttons
at the same time, all the transmitter LED’s turn on indicating that it is set in pairing mode. When a pairing signal is received from the receiver the
transmitter LED’s while turn off and the system is ready to be used. If no pairing signal received within 10s the transmitter will leave the pairing
mode.
4. Additional transmitters must be programmed according to step 2-3. You can pair up to 4 transmitters.
5. To clear all transmitters paired with the receiver hold the pair button on the receiver for approximately 10s until the LINK/ACT LED stops blinking.
When the LED stops blinking release the pair button. The receiver is then ready to pair with up to four transmitters.
MC_0202
!
Please refer to the graphic for special considerations relating to your model
!
Transmitter Installation and Battery Replacement
EN
1. Open the transmitter case by removing the 3 torx screws.
2. Remove the battery by inserting a screwdriver or similar between battery and holder at point A and fl ip the battery out, taking care not to damage
the battery grips at point B.
3. Insert the new battery (Type CR2032, 3V - Brand name recommended). Ensure to insert the battery with the positive pole up diagonally into the
battery holder, ensuring that the edge of the battery is under the battery grips (B). Press the battery down until secured at point A.
4. Close the transmitter. Put the cover back in place, ensure that the rubber seal between remote upper and the lower part is located correctly. Place
the 3 screws (remember sealing washer) in their recessed holes and tighten carefully.
MC_0178
!
Please refer to the graphic for special considerations relating to your model
!
IMPORTANT
Before working on the transmitter, deactivate the transmitter and the receiver (push “OFF” on the transmitter(s)) and turn off the power to
the receiver as well as the thruster main switch.
MG_0194
Battery
A
B
A
B
