14
2955
8
2020
-
RCT 20E, 21E, 22E, 23E & REMOTE RECEIVER
Transmitter Installation and Battery Replacemnet
EN
1. Open the transmitter case by removing the 3 torx screws.
2. Remove the battery by inserting a screwdriver or similar between battery and holder at point A and fl ip the battery out, taking care not to damage
the battery grips at point B.
3. Insert the new battery (Type CR2032, 3V - Brand name recommended). Ensure to insert the battery with the positive pole up diagonally into the
battery holder, ensuring that the edge of the battery is under the battery grips (B). Press the battery down until secured at point A.
4. Close the transmitter. Put the cover back in place, ensure that the rubber seal between remote upper and the lower part is located correctly. Place
the 3 screws (remember sealing washer) in their recessed holes and tighten carefully.
MC_0178
!
Please refer to the graphic for special considerations relating to your model
!
IMPORTANT
Before working on the transmitter, deactivate the transmitter and the receiver (push “OFF” on the transmitter(s)) and turn off the power to
the receiver as well as the thruster mainswitch.
MG_0194
Battery
A
B
A
B
