Installation & User Manual, Radio Remote rev 1_0_4
Page 15
The original transmitter and receiver have the same factory preset code so that no programming
is necessary. When additional transmitters are to be used, the additional transmitters has to be
paired with the receiver.
1. Be sure that there is power on the receiver (Green status LED blinking) and that the transmit-
ter that should be paired is off.
2. Push the Pair Button on the receiver to put the receiver in pairing mode (as shown above).
Both red and green led’s should start to blink simultaneously.
3. Within 10s after the receiver pair button is pushed, set the transmitter in pairing mode by
holding the off button and pressing both “ON” buttons at the same time, all the transmitter
LED’s turn on indicating that it is set in pairing mode. When a pairing signal is received from
the receiver the transmitter LED’s while turn off and the system is ready to be used. If no
pairing signal received within 10s the transmitter will leave the pairing mode.
4. Additional transmitters must be programmed according to step 2-3. You can pair up to 4
transmitters.
5. To clear all transmitters paired with the receiver hold the pair button on the receiver for
approximately 10s until the red and green led stop blinking. When the LED’s stop blinking re-
lease the pair button, the green led will again start to blink when the receiver has completed
the reset process. The receiver is then ready to pair with up to four transmitters.
Programming additional receivers
Pair Button
