Installation & User Manual, Radio Remote RC12E
Page 9
Important user precautions
• Ensure that you know the location of the main battery switch that disconnects the windlass
from all power sources (batteries) so that the windlass can be turned off in case of a malfunc-
tion.
•
How to activate the system:
Turn on the main power source for the windlass system. Turn on the power to the receiver.
The
windlass system is then activated by pushing the two “ON” buttons on the transmitter (see
page 10). To turn of the radio remote control press the “OFF” button on the transmitter for 2 sec.
The LED below the Pair Button on the receiver will blink when a command signal is received.
•
Alarms
:
If transmitter/receiver is out of range, the transmitter will give an alarm sound.
If the voltage of the battery supplying the windlass gets below 8V, the alarm will sound.
If other alarm situations are detected by the receiver, the transmitter will give an alarm sound.
• The transmitter will automatically turn off after approx. 4 minutes of inactivity for safety reasons
When using a single transmitter
The system turns off automatically approx. 4 minutes after the last usage.
When using more than one transmitter
The system turns off automatically approx. 4 minutes after the last usage of the control unit that
initially activated the system even if other control units have been operated in the meantime.
The system is off even if these other control units still show the blinking LED on the transmitter.
To use these transmitters, the system must be activated again by pushing the two “ON” buttons.
• Remember to turn off the radio remote control by pushing the “OFF” button on the transmitter
for 2 seconds and to turn off the power switch for the receiver when finished using your wind
-
lass
