Sleip
ner Mo
tor AS
• Norw
ay
ww
w.side
-powe
r.com
R
ed: 1
2/24V
Batt.
+ (5A
fuse!)
B
lack: 1
2/24
V
Batt
. -
5 A
Receiver Part# 8918A
F
used
power
supp
ly from
a
ci
rcuit w
ith ON
/OFF s
w
itch!
T
o bow
thrus
ter
Y
ellow:
Sidep
ower
autom
atic
m
ain sw
itch (o
ption
al)
T
o bow
thrus
ter con
trol p
anel
T
o stern
thrus
ter
Y
ellow:
Sidep
ower
autom
atic
m
ain sw
itch (o
ption
al)
T
o stern
thrus
ter co
ntrol p
anel
BOW
STERN
PROG
LED
The original transmitter and receiver have the same factory preset code so that no programming
is necessary. When additional transmitters are to be used, the receiver must be programmed
again for all transmitters.
1. Deactivate the receiver and all transmitters (press “OFF” on all transmitters).
Turn off the main power switch for the thruster(s).
2. Turn on the power to the receiver.
3. Remove the plastic plug from the receiver box (as shown above).
4. Press the “PROG” button at the receiver. The receiver is then in “Program mode”.
The receiver will stay in Program mode for 30 seconds,indicated by blinking LED
5. The receiver and transmitter are programmed by pressing both “ON” buttons on the transmitter
for about 2 seconds. During this 2 seconds the LED will change from blinking to continous light
when the programming signal is received. Turn off transmitter.
6. Additional transmitters must be programmed according to step 5 within the same 30 seconds
time period when the receiver is in “Program mode”.
7. Wait until the LED stops to blink. The total “Program mode” time is about 30 seconds.
The programming is now
fi
nished.
8. Turn on the transmitter(s) and check that the receiver LED is blinking slowly (User mode)
9. Turn off the power to the receiver and put the plastic plug back in place.
Installation & User Manual, Radio Remote 8980/8981
Page 7
Programming additional receivers
