SICLI COP3000, Руководство по установке

Страница: 15 / 45

Technical Specification
Power Supply (Approved EN54 pt 4)
Mains
Nominal Voltage
: 230 Vac + 10%, -15%
Nominal Current : 75mA
Maximum Current : 750mA
Input Fuse R1 : NTC SG39 Imax 4Amp
Output Voltage including tolerances : 26V = 18.5 to 29.5Volts
: 26V RAW = 18.5 to 29.5Volts
: 5Volt Output = 4.6V to 5.5V
Ripple Voltages : 26V = 800mV
: 26V RAW = 800mV
: 5Volt Output = 430mV
Maximum Loadings : 26V O/P = 0.98A
: 26V RAW O/P = 1.7A
: 5V = 0.5A
Standby Current (4 Loops Loaded) : 26V = 280mA
: 26V RAW = 150mA
: 26V = 280mA
: 26V RAW = 150mA
: 5V = 43mA
COP6000 is protected by an internal thermal device, this requires no maintenance
*
I
max a,
I
max b &
I
min = Current as specified in BSEN54-4 Published 2006 (Amendments 1 & 2)
Batteries
Number of Batteries : 2
Manufacturer: :YUASA NP12-12
Capacity : 12 Ah
Battery Fuse : 6.3A Anti-Surge (F4)
Maximum battery current; : 3.5 Amps
Standby current (mA) : 175 (4 loops), 125 (2 loops)
Maximum Charging Current to the Batteries : 1.0amp
Float Voltage : 27.4 Volts
Final Voltage : 21.0Volts
Charging Characteristics : Constant Voltage with 0.970A
limit with temperature compensation
Maximum current drawn from the batteries : 3.5Amps
when the mains is not available
Deep Discharge Protection
: 20.6 Volts
Battery Internal Impedance Fault : >0.5 ohms
Inputs
Addressable Loops
Max Number
: 1 - 4
Max Loop Load per loop : 220 mA
Max Number of Addressable Devices per loop : 220
Class Change : Operated by external volt free contact
Outputs
Conventional sounder circuits
Number of sounder circuits : 4
Total sounder Load : 1.5 Amps
Sounder Circuit Fuses (F1/2/3/4) : 1.6 Amp (Quick Blow)
End of line resistor : 6k8
Fire Routing Equipment
Max Load : 60 mA
Fused (PTC2) : 100mA polyswitch
End of Line resistor : 6k8
15
}
*
I
max a
}
* I min
}
*
I
max b
www.acornfiresecurity.com
www.acornfiresecurity.com