SICK UE4740, Руководство по эксплуатации

Страница: 23 / 44

Operating Instructions Chapter 7
UE4740
8020182/1CUO/2022-08-26 © SICK AG • Industrial Safety Systems • Germany • All rights reserved
23
Subject to change without notice
Configuration
7
Configuration
This chapter schematically describes the steps required to configure the EFI gateway and
its integration in the application.
7.1 Default delivery status
In the default delivery status the EFI gateway has the following configuration:

EFI connections:
– no devices expected

PROFINET IO
– PROFINET IO name: [without]
– IP address: 0.0.0.0
– PROFIsafe address: 1
7.2 Prerequisites for the configuration
Take sufficient time to plan the integration and the configuration of the EFI gateway. Take
into account that errors in the planning and configuration can endanger persons.
The following prerequisites must be fulfilled before you configure the EFI gateway:

The application must already have been planned completely. The planning must include
among other things:
– a detailed safety analysis of the planned application
– a complete list of all the required devices, their connections and the signals provided
by or required by these devices

The EFI gateway must be connected to the power supply (see section 5.1 “ Power supply
and EFI connections UE4740 ” on page 19).

The safety components must be connected electrically to the EFI gateway. To this
purpose read chapter 5
“ Electrical installation ” from page 18 on, as well as the
corresponding chapters of the operating instructions of the devices that you want to
connect to the EFI gateway.
If you use the CDS to change configurations via remote access, take into account that your
local time is set as the configuration time in the configuration. In the case of a time
difference between the locations this can cause short-term problems.
Note