SICK TiM4 Series, Руководство по эксплуатации

Страница: 26 / 42

6.2 Electrical block diagram for commissioning
TiMxxx-20xxxxx
SOPAS SOPAS
„Power/Out“
Konfiguration
Diagnose
TiM
Anschalt-
vorrichtung
DC 9 ... 28 V
Treiber für Mess-
wertanforderung/
Weiterverarbeitung
SYNC/
Device Ready
„Ethernet“
Ethernet Ethernet
Sicherung
0,8A/T
Figure 18: “Power, I/O” connection: With M12 male connector, 5-pin, A-coded; “Ethernet” con‐
nection: M12 female connector, 4-pin, D-coded
6.3 Wiring instructions
NOTE
Pre-assembled cables can be found online at:
• www.sick.com/TiM4xx
NOTICE
Faults during operation and device or system defects!
Incorrect wiring may result in operational faults and defects.
■
Follow the wiring notes precisely.
All circuits connected to the device must be configured as SELV or PELV circuits. SELV =
safety extra-low voltage, PELV = protective extra-low voltage.
Protect the device with an external 0.8 A slow-blow fuse at the beginning of the supply
cable.
Connect the connecting cables in a de-energized state. Do not switch on the supply volt‐
age until installation is complete and all connection work on the device and controller
has been finished.
Wire cross-sections in the supply cable from the customer’s power system must be
implemented in accordance with the applicable standards.
6.4 Connection diagram
NOTE
The recommended connecting cables and their associated technical data can be found
online at:
www.sick.com/TiM4xx
6.4.1 TiMxxx-20xxxxx
Power connection
1
4 3
5
2
6
ELECTRICAL INSTALLATION
26 O P E R A T I N G I N S T R U C T I O N S | TiM4xx 8026151//2020-11-15 | SICK
Subject to change without notice