2
Safety information
2.1
Intended use
The ICD880/890 device is an intelligent camera for identifying and decoding 1D codes
and 2D codes on moving objects. The device can also execute a variety of image pro‐
cessing algorithms. The processed image information and read results for the 1D codes
and 2D codes are transmitted via CAN or Ethernet to a higher-level SICK controller (e.g.,
MSC800 oder SIM) or directly to the customer system. The outstanding image quality
also makes the device suitable for use in OCR and video coding applications.
The device is always operated in a mechanical combination with a compatible, applica‐
tion-dependent variant of the ICI890 illumination. The device is mounted on the rear of
the illumination for this purpose and is electrically connected to the illumination. The
illumination is triggered by the device in the read cycle.
The device is designed for use in industrial applications and meets the requirements
for industrial ruggedness, interfaces and data processing. Additional functions related
to image processing can be developed and made available on request.
SICK AG assumes no liability for losses or damage arising from the use of the product,
either directly or indirectly. This applies in particular to use of the product that does not
conform to its intended purpose and is not described in this documentation.
2.1.1
Operating restrictions
NOTICE
Radio interference may occur when the device is used in residential areas!
■
Only use the device in industrial environments (EN 61000-6-4).
2.1.2
Conditions for specified enclosure rating
To ensure compliance with the specified IP65 enclosure rating of the device during
operation, the following requirements must be met: If these requirements are not met,
the device does not fulfill any specified enclosure rating.
•
The device is mounted flush to the illumination using all 4 screws.
•
The storage media cover on the rear of the device is screwed tight to the device.
For the recommended tightening torque for the cover screws,
•
The cables plugged into the electrical M12 connections on the sides of the device
are screwed tight.
•
Any electrical M12 connections that are not being used must be sealed with
protective caps, depending on type. These plugs or caps must be screwed tight (as
delivered).
NOTICE
Only operate the device
without the storage media cover
for a short period while
inserting or removing the optional storage media (SSD drive, microSD memory card).
During this time, protect the device against moisture and dust.
2.1.3
Using the USB interface
NOTE
The USB interface of the device is used in industrial environments only as a service
interface for temporary use (e.g. for configuration, troubleshooting). Permanent use in
operational use of the system as a host interface is not intended.
SAFETY INFORMATION
2
8023775/1A4I/2020-12-01 | SICK
T E C H N I C A L I N F O R M A T I O N | Camera ICD880/890 Generation 4
7
Subject to change without notice
