SICK GM32 Series, Руководство по эксплуатации

Страница: 47 / 80

47 8012707/ZVF9/V2-1/2019-04 | SICK O P E R A T I N G I N S T R U C T I O N S | GM32
Subject to change without notice
OPERATION
5
If you cannot see a focal point or adjustment is not possible:
– Is the gap between the device flange and the purge air fixture correctly adjusted? ( see
“Installing the device flange on the purge air fixture”, page 30 ).
– For GMP probe: Diaphragm (lever) open? ( see “Installing the SR-unit on the device
flange”, page 36 ).
– Large amount of dust or humidity in the gas duct?
– Window dirty? (
see “Cleaning the window”, page 50 ).
– Sender lamp defective? (Replacing the sender lamp, see “Checking and replacing the
desiccant cartridges”, page 50 .
Check cycle
Start the check cycle manually.
Reference cycle
Start the reference cycle manually.
5.2.5.5 Maintenance
Operating mode “ Maintenance ” is signaled via this menu.
●
“ Maintenance ” is displayed in the operating mode line.
●
The “ Maintenance mode active ” message is displayed.
●
A continuous display of “*” is shown.
●
The “ Maintenance ” status signal (
→
electrical connection diagram) is set.
Fig. 30: “Maintenance” screen
●
Button assignment:
–
“Back” : Show the “ Measuring ” menu - maintenance signal remains set.
– “ MEAS ”: Show the “ Measuring ” menu - maintenance signal is reset.
Information on the check cycle, see “Check cycle”, page 11 .
Information on the reference cycle, see “Reference cycle”, page 11 .